Death Wobble
So my 1997 Dodge Ram 1500, 5.9 Gas 4WD, shakes uncontrollably anywhere from 25-45 mph.I have to punch it from 20 to get upto 50, and at 50 it only has a slight shake. It may have just been mud, but it's done this before. And the truck has camber, unwanted camber. How do I fix the death wobble and camber? Ball Joints?
I want to do a complete refresh of the front end, I've got all new brakes and that stuff, but I want to do complete front end suspension. Is there any kits someone may know of for my truck? Thanks! |
Likely not death wobble, if you can speed up, and get thru it. Death wobble usually starts at higher speeds, and will not go away until you slow WAY down. Clean the mud out of your wheels, and see if anything changes.....
|
Shouldn't have any camber. Ball joints must be shot. Jack up the front enough to get a crowbar under the tire and yank upward while someone watches for play at the joints. You can find Chinese junk as a kit online that includes bj, track bar and tie rods but if you want to do it right get Moog or ac Delco parts. Then align it with zero toe and you're good.
|
Originally Posted by HeyYou
(Post 3401694)
Likely not death wobble, if you can speed up, and get thru it. Death wobble usually starts at higher speeds, and will not go away until you slow WAY down. Clean the mud out of your wheels, and see if anything changes.....
I bought some cheap ball joints on ebay to do for now, do you know if I'll definitely need a ball joint press or puller? I've never done ball joints |
It's fun on a 4x4. I would have the press handy, just in case.
|
What I do is put antiseize in the hole. I have to change both my uppers because they went bad (Moog) and only took them out with a Chisel and Hammer, and only took the tire off. Left everything else connected
|
Originally Posted by MoparFanatic21
(Post 3402312)
What I do is put antiseize in the hole. I have to change both my uppers because they went bad (Moog) and only took them out with a Chisel and Hammer, and only took the tire off. Left everything else connected
|
Originally Posted by Jaw91097
(Post 3402433)
What year? You think I could just do this with the same tools? I've gotta do both upper and lower and both sides. Take the nut off then just start whacking it till the S.O.B comes out?
|
I use a big hammer to get 'em out, and a press to put 'em back in.
|
Originally Posted by HeyYou
(Post 3402450)
I use a big hammer to get 'em out, and a press to put 'em back in.
|
All times are GMT -4. The time now is 07:44 AM. |
© 2024 MH Sub I, LLC dba Internet Brands