Dodge Dakota Center Console Plate Removal
#1
Dodge Dakota Center Console Plate Removal
How do I remove this plate on the floor console? The plate basically under the seat warmer buttons. There are 4 screws under the arm rest lid. But there seems to be more. The big gulp cup holder comes up but it snaps back into place. I'm just suck.
#4
There are a total of 7 screws holding the console down, 4 underneath the bottom of the main storage, 2 under the cup holders, and 1 under the front forward storage tray, on the left side. The heater switch plate is probably held in with clips of some sort, my console has another small storage bin where your heater switches are.
100_1543.jpg
Welcome to DF.
100_1543.jpg
Last edited by dakotaff; 12-28-2012 at 08:10 AM.
#6
Ok, so here is my console:
And this is the cup holder (little dirty, I just took the tray out):
[No screws there]
And that back there is the glasses holder:
[I see the bolt]
This is the inside of the armrest of course:
And lasty, this is the lip that is where the plate hits the actual console:
I have token the 4 top screws out and this plate comes up here. I want just the plate off which I noticed consist of taking out the big gulp cup and the bolt inside the glasses holder, if you saw the wires earlier it is a part of my CB radio, and I want to run the wires under/inside the console. If you can see to the left I managed to run it that far down the console so far, but I want them all near the end (I took my CB out for the pics). Hope this clarified a little! :P
And this is the cup holder (little dirty, I just took the tray out):
[No screws there]
And that back there is the glasses holder:
[I see the bolt]
This is the inside of the armrest of course:
And lasty, this is the lip that is where the plate hits the actual console:
I have token the 4 top screws out and this plate comes up here. I want just the plate off which I noticed consist of taking out the big gulp cup and the bolt inside the glasses holder, if you saw the wires earlier it is a part of my CB radio, and I want to run the wires under/inside the console. If you can see to the left I managed to run it that far down the console so far, but I want them all near the end (I took my CB out for the pics). Hope this clarified a little! :P
#7
Trending Topics
#8
Yeah, your definitely in the right section. The other two screws are under the large cup/bottle holder.
It pulls straight up to remove it, the bottom center is where it snaps into place. Just give it a nice tug, it's held in pretty good.
100_2752.jpg
100_2753.jpg
It pulls straight up to remove it, the bottom center is where it snaps into place. Just give it a nice tug, it's held in pretty good.
100_2752.jpg
100_2753.jpg
#9
Now I got this. Thanks!
Last edited by Gtt1239; 12-28-2012 at 07:46 PM.