LED turn signal problem
I just installed some led bulbs for the front turn signals, and i get a lamp out and they barely flash. I read up on this and found that installing a 6ohm 50watt resistor on each side works but the resistors gets hot (which i dont like). I checked online and found a LED turn signal relay, which replaces the stock relay. Has anyone ever used one of those and does it actually work?
|
if you are worried about the resistor getting hot there is a heat block you can put the resistor in, $1.00 at any radio shack. The resistor getting hot is not a problem, they do not get so hot as to melt anything? They are used in every LED application, one way or another...
|
You can use a higher watt resistor with a heat sink that will work also...
|
heat sink...thats what I meant, not heat block...thanks alph
|
All times are GMT -4. The time now is 07:20 PM. |
© 2024 MH Sub I, LLC dba Internet Brands