Because I can't just leave chit alone...
#1
Join Date: Jul 2007
Location: South Georgia/East Florida
Posts: 24,686
Likes: 0
Received 20 Likes
on
19 Posts
Because I can't just leave chit alone...
Well I'm gonna take the MIG off the shelf again this week. After basically touching my exhaust once over the last 5 years just to repair a broken hanger, I am about to cut and weld on it for the 3rd time in the last 3 months.
Even though the "Y" adapter I picked up 5 1/2 years ago was a whole lot better than the stock one, it still is a bit pinched down where they join, not to mention it's starting to look like the rust on it is getting to be a little deeper than just surface rust.
So, I bit the bullet, broke down and spent a whopping $26 on a Magnaflow "Y" adapter yesterday. It is roughly the same length as my existing one so installation should be a breeze. Dunno if it's gonna make much difference in flow, but with it being stainless, it should be the last one I ever need to put on...
Even though the "Y" adapter I picked up 5 1/2 years ago was a whole lot better than the stock one, it still is a bit pinched down where they join, not to mention it's starting to look like the rust on it is getting to be a little deeper than just surface rust.
So, I bit the bullet, broke down and spent a whopping $26 on a Magnaflow "Y" adapter yesterday. It is roughly the same length as my existing one so installation should be a breeze. Dunno if it's gonna make much difference in flow, but with it being stainless, it should be the last one I ever need to put on...
#2
#3
#7