When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
3rd Gen Ram Tech2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
I measured my fenders yesterday and it reads about 35 1/4" in the front and about 36" in the rear. I've searched around and it doesn't seem worth it to get a 2" leveling kit (if I only need 3/4") and block up the back if it still wont' level out right. What can I do to make up the 3/4" offset. I'll be installing a 3" PA Body lift in a few weeks (once it arrives!!!!yeah!!) and I want to make sure I can get the body level when I do it. Do you think a torsion adjustment will make up the difference or would I need to something more drastic.
Your bolts must already be partially cranked to be up that close. I know mine was a good inch and nearly a half low, I did keys and an aal to get it as even as possible, its really close, its 1/4" off.