3rd Gen Ram Tech 2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Odd tire wear

  #1  
Old 05-09-2011, 02:57 PM
wishywashy's Avatar
wishywashy
wishywashy is offline
Rookie
Thread Starter
Join Date: Jan 2011
Location: UT
Posts: 52
Likes: 0
Received 0 Likes on 0 Posts
Default Odd tire wear

I have odd tire wear on the passenger front tire. There is a band about an inch wide just above the curb side sidewall that is wearing much faster than the rest of the tire.

The tire is inflated properly and there aren't any pops or grinding from that side. I appreciate any help on where to start looking.



Name:  DSC00297.jpg
Views: 7
Size:  154.8 KB
Name:  DSC00298.jpg
Views: 7
Size:  134.5 KB
 

Last edited by wishywashy; 05-09-2011 at 08:53 PM.
  #2  
Old 05-09-2011, 03:12 PM
dirtydog's Avatar
dirtydog
dirtydog is offline
Moderate User
Dodge Forum Moderator
Join Date: Oct 2008
Location: Albany, NY
Posts: 17,003
Likes: 0
Received 18 Likes on 9 Posts
Default

Without a picture showing the wear, I'm going to associate it with an alignment issue. Have you checked the hub for any bearing play?
 
  #3  
Old 05-09-2011, 07:27 PM
HammerZ71's Avatar
HammerZ71
HammerZ71 is offline
Administrator
Dodge Forum Administrator
Join Date: Jul 2007
Location: South Georgia/East Florida
Posts: 24,686
Likes: 0
Received 20 Likes on 19 Posts
Default

When an inner or outer rib wears faster than than the rest of the tire, the need for wheel alignment is indicated. There is excessive camber in the front suspension, causing the wheel to lean too much to the inside or outside and putting too much load on one side of the tire. Your truck may simply need the wheels aligned, but misalignment could be due to sagging springs, worn ball joints, or worn control arm bushings.
 
  #4  
Old 05-09-2011, 08:54 PM
wishywashy's Avatar
wishywashy
wishywashy is offline
Rookie
Thread Starter
Join Date: Jan 2011
Location: UT
Posts: 52
Likes: 0
Received 0 Likes on 0 Posts
Default

I posted pics. What is that piece in the first picture and how much approx will it cost to be replaced? Thanks again guys!
 
  #5  
Old 05-09-2011, 09:23 PM
Ben D.'s Avatar
Ben D.
Ben D. is offline
Champion
Join Date: Oct 2006
Posts: 2,752
Likes: 0
Received 0 Likes on 0 Posts
Default

pretty sure it's a sway bar end link, or sway bar link however you wanna call it.. Should be under 100 bucks for the part and easily replaced with some hand tools..

I'm pretty sure that's what it is but I might be wrong
 
  #6  
Old 05-10-2011, 09:56 AM
HammerZ71's Avatar
HammerZ71
HammerZ71 is offline
Administrator
Dodge Forum Administrator
Join Date: Jul 2007
Location: South Georgia/East Florida
Posts: 24,686
Likes: 0
Received 20 Likes on 19 Posts
Default

I'm not surprised you are having wear issues and breaking stuff, that CV axle is at a very bad angle. Whatever lift or level you got on that truck is the root of your problems IMO. I'm betting your tie rods and ball joints aren't in the best condition either...
 
  #7  
Old 05-10-2011, 10:03 AM
Ben D.'s Avatar
Ben D.
Ben D. is offline
Champion
Join Date: Oct 2006
Posts: 2,752
Likes: 0
Received 0 Likes on 0 Posts
Default

+1 to hammer.. I didn't even see that at first glance.. But that CV axle does look like either there's a lift kit causing such an odd angle... or the cv axle is on the way to death
 
  #8  
Old 05-10-2011, 01:25 PM
wishywashy's Avatar
wishywashy
wishywashy is offline
Rookie
Thread Starter
Join Date: Jan 2011
Location: UT
Posts: 52
Likes: 0
Received 0 Likes on 0 Posts
Default

Does this picture look better? I had the truck jacked up in the first set so I could push and pull on the wheel/suspension parts. I didn't use the arm to jack it up, I had the jack more towards the center.

Name:  DSC00300.jpg
Views: 9
Size:  71.1 KB
 
  #9  
Old 05-10-2011, 01:44 PM
HammerZ71's Avatar
HammerZ71
HammerZ71 is offline
Administrator
Dodge Forum Administrator
Join Date: Jul 2007
Location: South Georgia/East Florida
Posts: 24,686
Likes: 0
Received 20 Likes on 19 Posts
Default

Now that's more of how a CV should look, but trust me, there are guys who have their trucks looking like the first photo with the tires flat on the ground.

Now I'm back to thinking it's more of an issue with your camber is off...
 
  #10  
Old 05-10-2011, 07:55 PM
Caseys-dodge's Avatar
Caseys-dodge
Caseys-dodge is offline
Veteran
Join Date: Feb 2010
Location: Houston, TX
Posts: 423
Likes: 0
Received 0 Likes on 0 Posts
Default

Yeah that piece is the sway bar link or support bracket. On my '02 I think the price was about $70, but after some reading on here, I opted to just remove the entire sway bar. That was over a year ago and it's still off. IMO the truck handles the horrible roads here much better. I do take corners pretty fast at times and never had much side to side sway. You can take the sway bar off for a few days and see how you like the handling before you decide to buy the new part
 

Thread Tools
Search this Thread
Quick Reply: Odd tire wear



All times are GMT -4. The time now is 09:46 AM.