Hemi swap
#1
Hemi swap
I swaped my 07ram with a 06 hemi wires in dash and motor it runs and drives now but my abs brake and air bag light are in every thing works at heat radio horn I’m trying to figure out why I have no codes I’ve only been able to find out that everyone says it’s a clock spring but I’ve replaced it any ideas ? Thank you
#2
#3
yea I changed the ecu and got it flashed for my vin and oh ok I’ll see if I can get the codes read I have a scanner but it says no codes but I’ll get my buddy to scan it with his snap on modes I think any idea what it could be tho ?
#4
#6
Need to figure out why it wouldn't run before that, 06 & 07 1500 engines are identical (if it was a 1500 to 1500 swap). Should have been plug and play with your existing onboard elex (PCM and wiring). You're getting problems because each year there are harness and computer variations, i.e. you're running a 2007 computer in your 2006 architecture and your truck doesn't like it.
#7
Need to figure out why it wouldn't run before that, 06 & 07 1500 engines are identical (if it was a 1500 to 1500 swap). Should have been plug and play with your existing onboard elex (PCM and wiring). You're getting problems because each year there are harness and computer variations, i.e. you're running a 2007 computer in your 2006 architecture and your truck doesn't like it.
Trending Topics
#8
#10
You turned something straightforward into a sh!tshow electrical nightmare. U codes are module communication problems. As per any reference I have, U1416 doesn't exist for Mopar. You sure it isn't P1416?
You LITERALLY should have just dropped it in and hooked everything up and it would've been fine. That engine didn't need the donor electronics smh.
You LITERALLY should have just dropped it in and hooked everything up and it would've been fine. That engine didn't need the donor electronics smh.