I'm thinking about installing a magnaflow Y pipe on my 09 hemi ram QC. I am a welder by trade, I can do the welding, but is there any tube bending required for this or is it a matter of cutting the factory pipe out and slip the new Y in and weld it up?Any of you guys done your own I would like to hear how it went. Thanks.

 

I forget the p/n but magnaflow makes one....check out there site!

 

Yeah I know Magnaflow makes a Y pipe for 09 and up rams, I was asking if any tube bending is required to get it to fit or if it just slips in after cutting stock exhaust to correct lengths.