Location of Cam Shaft Sensor
 

I am looking for the location of the Cam Shaft sensor on an 04 Dodge Intrepid SXT. The engine light shows codes for both banks for the cam shaft sensor and the car stalls when driving I thought that I should start with replacing this sensor first before I moved on to the O2

You can go to autozone.com and select your car type and engine liter and then go to sensor location and it will tell you everything you need to know.

in the front of the motor near the camshaft pulley there should be only 1 bolt holding it on.

REMOVAL - 2.7L

The camshaft position sensor is mounted in the front of the head.

1. Disconnect electrical connector from sensor.
2. Remove camshaft position sensor screw.
3. Without pulling on the connector, pull the sensor out of the chain case cover.

REMOVAL - 3.5L

The camshaft position sensor is installed in the timing belt housing cover above the left camshaft sprocket.

1. Disconnect the negative battery cable.
2. Loosen the upper intake plenum, refer to the Intake System section.
3. Disconnect electrical connector from sensor.
4. Remove camshaft position sensor screw.
5. Pull sensor up out of the timing belt housing cover.