1978 B300 V8 400 - oil pan removal easy?
The Haynes manual says I need to lift the engine but wondering if it's possible to weasel out.
|
Originally Posted by MarkLDN
(Post 3318380)
wondering if it's possible to weasel out.
|
Fantastic.. Thank you for confirming Alloro!
|
On the V6 I had to remove the right side engine mount and loosen the left one. I raised the engine trans together up about 3" or 4" just enough to clear everything. FYI yes drop the exhaust, as the pan will need to clear it. I jacked up the motor and cut a 2X4 and stuck in where the motor mounts locate and removed my jack. Jack stand at the rear of the trans. Be careful when reinstalling the oil pump, as it has to fit flush with the engine block.
Watch this video and he explains why. |
Originally Posted by Doc Joe
(Post 3318511)
On the V6 I had to remove the right side engine mount and loosen the left one. I raised the engine trans together up about 3" or 4" just enough to clear everything. FYI yes drop the exhaust, as the pan will need to clear it. I jacked up the motor and cut a 2X4 and stuck in where the motor mounts locate and removed my jack. Jack stand at the rear of the trans. Be careful when reinstalling the oil pump, as it has to fit flush with the engine block.
Watch this video and he explains why. https://cimg5.ibsrv.net/gimg/dodgefo...6d18f515f.jpeg So, in order, you loosened both engine mounts, raised the engine with a floor jack 3-4 inches, and put two pieces of 2x4 inbetween the engine and mounts? Or you only did this to one side? What do you mean by "floor jack at the rear of the trans"? Is this where you placed it to raise the engine or was this to just raise the vehicle so you could work on it after you raised the engine? |
|
On my van I jacked up the engine/trans and once up I placed a jack stand at the rear of the trans to help support the trans and engine combo. While the 2X4 in the engine mount locations held the front of the engine. Keep the whole thing level is what I was shooting for.
The above picture was taken from my Dodge dealership service manual and this is what it says for both of the V8 engines. Different from the V6/3.9 engine. |
Thanks again Doc! Very helpful.
|
Are you replacing the oil pump?? If so put some oil into the pump to prime it, I did not do this step and it cost me time.
|
All times are GMT -4. The time now is 02:22 AM. |
© 2024 MH Sub I, LLC dba Internet Brands