Fuel Pump Relay Bypass question
 

Omron G8h-UA-007001

I am trying to run a continuity check from PDC to fuel pump C121 harness. Does anyone know which blade on Fuel relay corresponds to wire running to fuel pump harness?

Thanks

I hope this is what you are looking for.
TEST ACTION APPLICABILITY
4 Ignition Off
Disconnect the Fuel Pump Relay.
Note: Check connectors - Clean/repair as necessary.
Ignition on, engine not running.
Using a Voltmeter, measure the Fused Ignition Switch Output Circuit.
Is the voltage above 10.0 volts?
All
Yes ® Go To 5
No ® Repair the open Fused Ignition Switch Output Circuit.
Perform Powertrain Verification Test VER-2A.
5 Ignition Off
Disconnect the Fuel Pump Relay.
Note: Check connectors - Clean/repair as necessary.
Using an Ohmmeter, measure across Terminals 85 and 86 of the Fuel Pump Relay for
resistance.
Is the resistance below 100.0 ohms?
All
Yes ® Go To 6
No ® Replace Fuel Pump Relay.
Perform Powertrain Verification Test VER-2A.
6 Ignition Off
Disconnect the Fuel Pump Relay.
Note: Check connectors - Clean/repair as necessary.
Disconnect the Powertrain Control Module.
Note: Check connectors - Clean/repair as necessary.
Using an Ohmmeter, measure the Fuel Pump Relay Control Circuit for resistance
from PCM to Relay.
Is the resistance below 5.0 ohms?
All
Yes ® Go To 7
No ® Repair the open Fuel Pump Relay Control Circuit.
Perform Powertrain Verification Test VER-2A.
7 Ignition Off
Disconnect the Fuel Pump Relay.
Note: Check connectors - Clean/repair as necessary.
Disconnect the Powertrain Control Module.
Note: Check connectors - Clean/repair as necessary.
Using an Ohmmeter, measure the resistance of the Fuel Pump Relay Control Circuit
to ground.
Is the resistance below 5.0 ohms?
All
Yes ® Repair the Fuel Pump Relay Control Circuit for a short to ground.
Perform Powertrain Verification Test VER-2A.
No ® Go To 8
8 Turn Ignition Off.
There are no potential causes remaining.
View repair options.
All
Repair
Replace the PCM.
Perform Powertrain Verification Test VER-2A.
178
DRIVEABILITY
P-1282 FUEL PUMP RELAY CONTROL CIRCUIT — Continued

Thanks for the info. It will serve as a useful source of info for future readers. I will check it all out. Right now I have the filter off to check it. I have another post related to that.

Where would that terminal be? #85 86 etc

ok thats clear.

OK what terminal are we talking about on the fuel pump relay?

Looking for terminal location again.