DodgeForum.com - Search Results

Go Back  DodgeForum.com > Search Forums
Reload this Page >

Search Results

Search: Posts Made By: Patrick Dennis
Showing results 1 to 7 of 7
Search took 0.07 seconds.
08-07-2014, 10:29 AM
Replies: 14
Views: 33,494
Posted By Patrick Dennis

I'm not quite sure what you mean about...

I'm not quite sure what you mean about "unthreaded leads". Do you mean that the fittings do not have a lead-in to the threaded body, or the fittings are totally unthreaded? All of the fittings on my...
08-06-2014, 10:04 PM
Replies: 14
Views: 33,494
Posted By Patrick Dennis

Just replaced every hard brake tube on my "97 -...

Just replaced every hard brake tube on my "97 - due to a rust-through on the rear (exciting when this blew under a panic stop!). The lines are 3/16, the fittings at the calipers are M10X1.0, the...
04-12-2011, 06:59 PM
Replies: 8
Views: 885
Posted By Patrick Dennis

Re: HIDS. I tried two different kits, one was a...

Re: HIDS. I tried two different kits, one was a dual filiment, which worked terribly (poor pattern). The second was a single filiment,electro-magnetically moving the bulb for Hi/Lo operation. Light...
04-10-2011, 06:04 PM
Replies: 8
Views: 885
Posted By Patrick Dennis

That's correct - I have a 97, not familiar with...

That's correct - I have a 97, not familiar with the diagram of the later Gen 2 Dakotas.
The PDC is the "Power Distribution Center" in the engine compartment. RD/OG is the colors of the wire you are...
04-06-2011, 04:18 PM
Replies: 8
Views: 885
Posted By Patrick Dennis

Fog Light operation w/high beams

Yes there is a simple solution. I had posted this previously. In your PDC, remove the RD/OG lead at Fog Lamp Relay # 1, Pin # 85. Add a separate ground lead. This disables the hi beam interference...
12-08-2010, 09:39 PM
Replies: 74
Views: 21,549
Posted By Patrick Dennis

I installed the O/H consol from a 98 Durango in...

I installed the O/H consol from a 98 Durango in my 97 Dakota - but I pulled the complete wiring harness, plugs, etc with it. I spent a lot of time studying the Durango & Dakota wiring diagrams to...
12-08-2010, 09:14 PM
Replies: 8
Views: 835
Posted By Patrick Dennis

Bi xenon problem

Had a similiar problem with my '97. Found the feed back from the high beam circuit to the Fog Lamp relay#1 was the problem. I cut the L3 (RD/OG) lead to pin # 85 and added a separate ground. This...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.