DodgeForum.com - Search Results

Go Back  DodgeForum.com > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: KillerKilgore
Showing results 1 to 25 of 205
Search took 0.06 seconds.
06-13-2019, 07:44 AM
Replies: 19
Views: 20,271
Posted By KillerKilgore

You need to start your own thread. This is a very...

You need to start your own thread. This is a very old thread. Having said that. My issue was grounds.

Recommend checking all wire connections and ground locations. Spray with a electric cleaner....
01-13-2016, 10:16 PM
Replies: 15
Views: 1,920
Posted By KillerKilgore

Or, I could put a ??? ohm resistor on each of the...

Or, I could put a ??? ohm resistor on each of the wires on the sending unit connector, remove the sending unit completly, and ground the resistors.

That way the gauge would read sonething. The...
01-11-2016, 05:55 AM
Replies: 15
Views: 1,920
Posted By KillerKilgore

You are correct. For the moment, the light...

You are correct.
For the moment, the light only comes on at startup, 5-20 seconds later it's off.

I'll order one, along the O2 sensor by the cat that I need.

I'm sure it will set some kinda...
01-10-2016, 07:50 PM
Replies: 15
Views: 1,920
Posted By KillerKilgore

26272 26273 Yep, that is the...

26272

26273

Yep, that is the distributor cap. Didn't have socket or wrench. Channel locks and it was a pain.
See the small leak where nipple connects to block.
I think it is actually leaking...
01-10-2016, 12:15 PM
Replies: 15
Views: 1,920
Posted By KillerKilgore

I put on a brass nipple, a brass T, the old...

I put on a brass nipple, a brass T, the old sending unit, and the connection for the mechanical gauge.

It was a Bosch 2" mechanical gauge. Right now just have the included nylon hose running into...
01-09-2016, 09:27 PM
Replies: 15
Views: 1,920
Posted By KillerKilgore

Well, there goes the pipe tape ideal.

Well, there goes the pipe tape ideal.
01-09-2016, 05:36 PM
Replies: 15
Views: 1,920
Posted By KillerKilgore

Well good news to report. Put on nipple,...

Well good news to report.

Put on nipple, brass T, old sending unit, and mechanical gauge.
Started and mechanical gauge immediately went to 70psi. Electric gauge took 3 seconds to start to read....
01-09-2016, 12:15 PM
Replies: 15
Views: 1,920
Posted By KillerKilgore

I'm a firm believer in KISS (Keep It Simple...

I'm a firm believer in KISS (Keep It Simple Stupid).

Really didn't know synthetic didn't sludge.

Only run the dodge on weekends(wife has a Blazer, I drive company van Dodge Ram CV and gone most...
01-09-2016, 12:19 AM
Replies: 43
Views: 3,504
Posted By KillerKilgore

Just a thought. When the pressure cap...

Just a thought.
When the pressure cap releases(@ 17psi). The coolant goes into overflow.
What if the tube connected to that nipple wasn't tight and the coolant just ran to the ground.
Once the...
01-08-2016, 08:07 PM
Replies: 15
Views: 1,920
Posted By KillerKilgore

Back flush oil pickup tube?

Got a '97 3.9 4x4 187000 miles. Has been parked a few months (working too much).

Stated and drove a few days ago. Good oil pressure. Drove to store 5 minutes away. Let it set for 5? minutes,...
08-27-2014, 11:55 PM
Replies: 34
Views: 3,060
Posted By KillerKilgore

Was skimming through that thread. Saw a guy...

Was skimming through that thread. Saw a guy already ask for it.
Guy here is only asking 25 for his. Any one I want.

That is what I'm going to do is take off the clutch. It's new 50 wasted bet the...
08-27-2014, 10:54 PM
Replies: 34
Views: 3,060
Posted By KillerKilgore

Thanks brother. Been self-employed for little...

Thanks brother. Been self-employed for little over 2 years. Doing 3rd party contracts.
Now that I've gained employment phone been ringin' off the hook wanting me to go here or there and do work.
3...
08-27-2014, 02:40 PM
Replies: 34
Views: 3,060
Posted By KillerKilgore

Flushed cooling system. Drained radiator and...

Flushed cooling system. Drained radiator and block.
Then bottom hose on filled with water and left top hose off.
Run truck with top hose off and water hose in the radiator to
make sure it was a...
08-27-2014, 12:41 PM
Replies: 16
Views: 1,309
Posted By KillerKilgore

Do you leave the whip up 24/7 or is it bent down...

Do you leave the whip up 24/7 or is it bent down toward the front.

Had to remove my whip when I ripped the bumper off.
I have an old Cobra 29LTD ST (had a buddy adjust it) and a K40 4' whip...
08-11-2014, 08:23 AM
Replies: 34
Views: 3,060
Posted By KillerKilgore

Found the below radiator just a few questions...

Found the below radiator just a few questions maybe you guys can answer.

Existing Rad does NOT have external trans cooler.
New one DOES but there is room between rad and AC condenser.
New one...
08-08-2014, 11:28 PM
Replies: 34
Views: 3,060
Posted By KillerKilgore

Yesterday 8/7/14 after puttin 60ish miles on...

Yesterday 8/7/14 after puttin 60ish miles on water/ iron out.
Popped cap on radiator. Black water. Drained and flushed rad and engine 3 times.
Filled water and another cup of iron out. Made sure...
08-07-2014, 01:34 PM
Replies: 34
Views: 3,060
Posted By KillerKilgore

In '90 had and '80 Firebird Formula the fitting...

In '90 had and '80 Firebird Formula the fitting in radiator for trans line stripped.
The AC did work anyway so I used the AC condenser as a trans fluid cooler.
Worked like a charm. Think I plumed...
08-07-2014, 12:56 AM
Replies: 34
Views: 3,060
Posted By KillerKilgore

After reading this may have another cause for my...

After reading this may have another cause for my issue.

I got a ladder rack. 6' 8' & 10' ladders. diamond plate tool box full of stuff (2 and 4 lb sledge crowbar chisels 2' 3' and 6' flex drill...
08-07-2014, 12:18 AM
Replies: 14
Views: 35,602
Posted By KillerKilgore

COPY THAT especially when the boss man is in the...

COPY THAT especially when the boss man is in the passenger seat.

He was pumpin' the brakes harder and faster than I was.
08-06-2014, 10:57 AM
Replies: 34
Views: 3,060
Posted By KillerKilgore

@ jondakotaguy You must have posted while I...

@ jondakotaguy

You must have posted while I was replying. Any way, I like your setup.
Was checking out the link you gave but haven't went all the way through it yet.
Looks good and that is what...
08-05-2014, 02:49 PM
Replies: 34
Views: 3,060
Posted By KillerKilgore

@ Dodgevity I was afraid of blowin' a head...

@ Dodgevity

I was afraid of blowin' a head gasket as well. When it got that hot I was still enroute so I backed out of the peddle.
I kept checkin on the oil and see no sign of coolant in it. Not...
08-05-2014, 02:05 AM
Replies: 34
Views: 3,060
Posted By KillerKilgore

Another HOT dakota issue

Sorry for the long post.

Dakota getting hot. here is the history

Late last fall had to fix a heater core that was stopped up.
Took off heater hoses and mixed 1 bottle CLR to gallon of water...
08-05-2014, 12:58 AM
Replies: 14
Views: 35,602
Posted By KillerKilgore

If one line rusted into the other 2 are not far...

If one line rusted into the other 2 are not far behind. When you fix one line you WILL put pressure on the remaining old lines and be back working on the brakes in a week or two. been then done that....
07-13-2014, 01:25 PM
Replies: 17
Views: 1,544
Posted By KillerKilgore

Sounds like you got it fixed. Good to hear. ...

Sounds like you got it fixed. Good to hear.
Nothing like fixin something yourself.
07-09-2014, 09:32 PM
Replies: 5
Views: 864
Posted By KillerKilgore

Old trick but still works.

Was heading out to a job Sunday and the Check Gauges light came on. WTF

Everything looked OK then seen the temp was pegged.

Well spend the rest of the trip with HEATER WFO

With in 5...
Showing results 1 to 25 of 205
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.