Hi, I have a 2011 Dodge Citadel and need to replace driver's side high beam head light, but I don't see a way to access it, I read that there is a round access from the wheel well but just seems all I can access is the hid head light, any info or directions would be appreciated, thank you!

 

BULB - HEADLAMP


CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.

1. Disconnect and isolate the battery negative cable.
2. Remove the engine air filter housing if necessary for access to the back of the front lamp unit from the engine compartment.
3. Firmly grasp the low beam or high beam bulb base on the back of the front lamp unit housing and rotate it counterclockwise about 30 degrees to unlock it.
4. Pull the bulb and base straight out from the keyed opening in the reflector.

 

Thank you so much for taking the time to reply to my post!!

 

Your welcome. Post up if you were able to get your bulb changed.

 

Just want to let you know I was able to change the light bulbs, thanks again for the info!