You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
4th Gen Ram Tech2009+ and up Rams: This section is for TECHNICAL discussions only, that involve the 2009 and up Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
I tried the procedure in the manual about 15 times, no luck. Is there a trick to it? Any help would be appreciated........Kevin.
I haven't read the book, but all I do is put the key in the on position and push the gas pedal 3x and put the key in the off position. To be safe, I leave my door open so the truck still isn't powered for the stereo and such, once completely off, I'll put the key back in and start up. good to go.
I haven't read the book, but all I do is put the key in the on position and push the gas pedal 3x and put the key in the off position. To be safe, I leave my door open so the truck still isn't powered for the stereo and such, once completely off, I'll put the key back in and start up. good to go.
hope it helps...
I'll go try that, I'm hoping to.Thanks..............Kevin.
Aren't you supposed to put the key in and turn it to the ON position, but not start the truck......then floor the gas 3 times within 5 seconds? That's what I do and it seems to work.
__________________ 2009 Dodge Ram Sport Crew Cab
2006 BMW 550i
2008 Chevrolet Corvette Z06
Actually according to the manual, you turn the key to the on position(don't start vehicle) push gas 3 times slowly within 10 seconds then turn the key to the off position.
P.S. As it turns out I was turning the key to the 1st position(accessory) and doing the other steps. I did this at least 15 times,lol lol.Time for a shot........................................Kevin.
Aren't you supposed to put the key in and turn it to the ON position, but not start the truck......then floor the gas 3 times within 5 seconds? That's what I do and it seems to work.
Can't get the change oil light to reset.
I did this at least 15 times,lol lol.Time for a shot........................................Kevin.
