i removed the nuts on the hub, ans now i caint figure out how to remome the driveshafts on a 95 2.5 automatic, any help?

 

By Halfshaft to you mean CV Axle?

If so just tap the axle through the hub with a center punch, pull it all the way out and then get under the trans and tap the axel out. Get a pan tho its gonna leak fluid.

 

kool, ill give it a try

 

Oh and becarfully not to tear the boots I did that already chaning my axel seal, the boots are harder to change but its cheaper than buyin a whole new one

 

im sellin the transmission, could i just cut the shafts?

 

Cut the shafts??? What do you mean? they just pop out with a hammer and prybar. Unless you talkin about at the boots you want to just cut them then yeah. Then hit the hub off to separate it from the axel. Hold on Im at work Ill gett the proper name for the stuff so I won't confuse you.

 

/yes a grinder or skill saw can hack thry the shafts in no time ...

 

Mybad I the site was down all day and I got stucked logged in at work. So y are you cuttingthe shafts again?

 

he wants to sell the tranny but not take time to remove the shafts ...
one of my car club members launched his tranny could be pushed forward but not in reverse so we pushed it on a trailer but had to cut the shafts to roll it off

 

Ohh! I thought it be esier pull in both shafts its puttin it all back together.