1st Gen Dakota Tech 1987 - 1996 Dodge Dakota Tech - The ultimate forum for technical help on the 1st Gen Dakota.

Dodge Dakota cruise control and truck not shifting gears

Thread Tools
 
Search this Thread
 
Old Oct 2, 2008 | 09:58 AM
  #1  
texastig's Avatar
texastig
Thread Starter
|
Registered User
Joined: Oct 2008
Posts: 16
Likes: 0
Question Dodge Dakota cruise control and truck not shifting gears

I just found this forum and I'm new here.
I've been looking for years for help with these problems. My truck has been sitting for years because of the truck not shifting correctly.
I have a 93 Dodge Dakota 3.9L, V6.
When taking off from the house down the road I press the gas pedal and take off and the truck rpms rev up real high and it doesn't change gears until I let off of the gas pedal. Then it shifts into another gear.
This happens all the way down the road while getting to the speed limit.

Also, my cruise control stopped working. I checked the fuse and it's fine.

Any help would be be appreciated and I'd like to get my Dodge Dakota working again.

Thanks
 
Reply
Old Oct 2, 2008 | 12:53 PM
  #2  
codydakota's Avatar
codydakota
Captain
Joined: Mar 2006
Posts: 553
Likes: 0
From:
Default

sounds like the kickdown is out of adjustment, it's located on the left side of the transmission. Loosen the adjustment screw locknut 5 turns and make sure it turns freely, if necessary use some penetrating oil. tighten the adjusting screw, this is not the locknut, but the screw in the middle of it, tighten to 72in/lbs then back it off 2 1/2 turns, hold this screw so it don't move then tighten the lockunt to 30in/lbs, and see if that helps
 
Reply
Old Oct 2, 2008 | 02:10 PM
  #3  
texastig's Avatar
texastig
Thread Starter
|
Registered User
Joined: Oct 2008
Posts: 16
Likes: 0
Default

Cody, is that looking from the front of the vehicle or from the back for the left side of the transmission?
Thanks for your help. I appreciate it very much.
 
Reply
Old Oct 12, 2009 | 04:27 PM
  #4  
akabullseye's Avatar
akabullseye
Registered User
Joined: Oct 2009
Posts: 1
Likes: 0
Default

Hey Tig, did that correct your issue? I have the same issue on my 93 V8 4x4 with an added symptom. The day after having the late **** start the trany will no longer go into Park all the way. I read somewhere that there is an Iron washer in the governer that break and I'm thinking it fit my symptoms better. Any one else ever see this situation?
 
Reply
Old Oct 12, 2009 | 04:37 PM
  #5  
Crazy4x4RT's Avatar
Crazy4x4RT
Hall Of Fame
Joined: Aug 2007
Posts: 10,923
Likes: 19
From: NM
Default

Originally Posted by akabullseye
Hey Tig, did that correct your issue? I have the same issue on my 93 V8 4x4 with an added symptom. The day after having the late **** start the trany will no longer go into Park all the way. I read somewhere that there is an Iron washer in the governer that break and I'm thinking it fit my symptoms better. Any one else ever see this situation?
If you can't get it into park most likely it is the shift linkages. There is an adjuster your adjust to get it to line up correctly.
 
Reply
Old Oct 13, 2009 | 05:57 AM
  #6  
texastig's Avatar
texastig
Thread Starter
|
Registered User
Joined: Oct 2008
Posts: 16
Likes: 0
Default

Originally Posted by akabullseye
Hey Tig, did that correct your issue? I have the same issue on my 93 V8 4x4 with an added symptom. The day after having the late **** start the trany will no longer go into Park all the way. I read somewhere that there is an Iron washer in the governer that break and I'm thinking it fit my symptoms better. Any one else ever see this situation?
I changed the TPS and it fixed the shifting problem.

Cruise control is still kaput.
 
Reply




All times are GMT -4. The time now is 06:41 PM.