Turner signals?
I have a 96 Dakota and my right turn signal sticks. When I turn on the right blinker, inside flasher and the turn signals outside stick. Left one works fine. I have already replaced the flasher in the fuse panel. Does anyone know whats going on?
If you mean the turn signal clicks on without blinking, you probably have a burned out bulb.
Last edited by 95_318SLT; Feb 22, 2010 at 07:37 PM.
Check your bulbs front and rear. You probably have a two-filament bulb, one for parking lights, the other for turn signals. If your turn signal lights up but doesn't flash, the xperts say you have a bad bulb...or one filament in a bulb is touching the other filament. If that's not the cause, you have the same problem I have with my Dak...crappy Mopar wiring. I'm in the process of bypassing my turn signals with a new add-on circuit...hope you are luckier.
Check your bulbs front and rear. You probably have a two-filament bulb, one for parking lights, the other for turn signals. If your turn signal lights up but doesn't flash, the xperts say you have a bad bulb...or one filament in a bulb is touching the other filament. If that's not the cause, you have the same problem I have with my Dak...crappy Mopar wiring. I'm in the process of bypassing my turn signals with a new add-on circuit...hope you are luckier.
If the bulbs look fine. I would then start looking for a grounding positive wire. I've picked up many trailers and have had a turn signal stick because one of the positive wires were touching the trailer chassis.



