Hi everyone, me again. As I am going to mount my visor tomorrow (hopefully), I need to run the wires to the headlight switch. My question is, how do you remove the inside trim on the A-pillar? I don't see any visible screws holding it on, but the top and bottom come loose, whereas the middle part (by the dash) is tight. Is there a screw hidden by the dash there? I don't want to have to take the whole dash out to remove that pillar trim piece...Any suggestions would be appreciated...

 

It all slides on/off but several overlap. The kick panel and door seal are screwed down then remove them one at a time till you get what you need.

 

I got the lower kick panel off and popped the top out of the rear panel for the extended cab, but it really seems to me like where it bends by the dash there is a screw or something holding it in, as the ends are free but the middle isn't...

 

When in doubt rely on the service manual. You can download it in the FAQ.