hi guys i got the tranny in my 92 dak and i switched the crank pos sensor and now my motor wont even turn over i did for get to disconect the baterry and i zaped the starter a few times and i dont have any of the wires to the tranny hooked up yet but it still should turn over right? all my fuzes and rewlays r good so i was thinking i fried the starter or the nutral safty switch and i dont know where that is help plz

 

ok i can jump the starter with a skrewdriver and turn the motor over but it wont start so i switched the wires on the crank pos sensor and jumped it again and still wont start so i think it might be nutral safty switch help me plz.

 

ok i got the motor to turn over now it was the nutral safty but now i have no spark what could it be. the cps backwards? i fliped the wires again and still no spark another thing i was thinking was do i have to have the manual ecu to go with everything else?

 

Are you sure you hooked up the wires correctly on the crank sensor? Double check with the wiring diagrams in the FAQ. That would be my best guess.

 

i got my truck to start but i found out i have a new venture gear nv3500. dont know if thats good or bad but my auto cross member wont bolt up to it so i might have to fab one or get a manual one and a manual drive shaft

 

you should be able to go to the store and get the correct mount.