i have a 00 durango with the 5.2 2wd. the abs and brake lights stay on due to the fuse being removed. ( it was pulled out before i bought it). i put a new fuse in and the pump begins to run with NO key in the ignition. i have read several thing and some have said the pump shaft may have sheared. is there a way to check this short of pullong everything apart and if the shaft is good what else could it be?

 

your abs computer is out

 

that was the other thing i was thinking it could be. is there any way to tell for sure what the problem is?

 

my money is on the computer being out, i believe one member on here got his rebuilt tofix this problem

 

I will have to try that. Any ideas where i could go to have it rebuilt

 

http://www.modulemaster.com/en/abs/kh325d_125.php

 

If the ABS pump is constantly running without even the key being in the ignition then the ABS CAB (the ABS module) is bad and needs replaced. Best thing to do is have YOURS rebuilt and re-install it.