So lot's to do
 

OK so in the next 2 weeks I'll be spending about $1500 or so. Here is the list.

$500 for Hood, Fenders, Grill, Upper Bumper and Spindles. great deal, guy needs stuff gone so I'll take it. LOL

$164 for Plugs, wires, Cap, Rotor and Coil. Plus oil change.

$40 for Trans Speed Input and Output Sensors.

$612 For Front Pads, Rear Shoes, Rotors, CV Half Shafts, Front and Rear Stabilizer Bushings, Lower Bumper Cover, Turn Signal Assembly, AC Compressor, Belt Tensioner, Trailer Hitch and Hitch Wiring Harness

$40 for Drops Shackle Bolts for TS lift

$140 for Steering Column

$300 for 2 tires for the front.

And a few other things i can't remember right now. So soon you all will see a new improved Dirtrango. I can't wait to get this done.

P.S. already did the shocks their basic but will be swapped out in a few months.



:icon_headbang::icon_headbang::icon_headbang:

and ?

:icon_worthless:

Agreed! Cant wait to see em

Well I have to get them I did say i was getting the parts in the next 2 weeks so just be patient my friends. Should have the money in the bank Friday and if so going to get the front clip and spindles and ordering the plugs and wires. I will try to take pics of everything I do, or have my friend do that is. LOL

Ok so will have the money tonight and tomorrow starts the shopping spree. I feel like a kid on Christmas Eve. lol

Before and After pics please! And when I walk into my 2nd job every night I feel the same way (considering I work at an autoparts store and get LOTS of free parts!)

So about $800 spent just waiting for all of it to get here. have to go to LI for the fenders, hood, grill and upper bumper + the Spindles. Will take pics of everything and then before and after with some write up's if I can.

Upto $1050.86 damn. well after this if I have a problem I know it won't be with the truck. LOl

Ok update.

new plugs, wires, cap, rotor and coil are installed. I also did a temporary coil relocation and have to do a little mod to make it permanent.
http://i68.photobucket.com/albums/i3...5-28130932.jpg

here is the Coil relocation's temp position.
http://i68.photobucket.com/albums/i3...5-28130927.jpg

Should be putting in the Cv axles, upper and lower ball joints, inner and outer tie rods, control arm bushings, rack and pinions bushings, front and rear sway bar bushings, new disc's and pads for the front all next weekend. I will take before and after pictures while doin the tear down and reinstall. I didn't get the new front end yet so that will be another topic another day.

here are some pics of all the new stuff.

http://i68.photobucket.com/albums/i3...5-23125333.jpghttp://i68.photobucket.com/albums/i3...5-23124925.jpghttp://i68.photobucket.com/albums/i3...5-22134817.jpg
http://i68.photobucket.com/albums/i3...5-22124245.jpg

Also picked up a new tool set for good measure.
http://i68.photobucket.com/albums/i3...5-22124251.jpg


Well more updating next week. just hope it all goes good and no :icon_stooge: .