2002 D 4WD ..What did I miss..AGAIN ! Changed one side upper /lowers had a #%$*&^ getting the Knuckle/spline/Lower BJ to align and clear without binding/forcing something ..now the drivers side BJ's are installed and time to get this all aligned up to install the knuckle w/o damaging anything..
ANY tips ? every video I saw this was omitted ..
So..
1. Should I have both sides off the ground ?
2. Any pressure to release to push the spindle in further without it pushing back out ?
3. Turn steering opposite
I know some things don't make sense But I'm grasping !!
Any tips ?
Thanks in advance..

 

Sorry but none of that made sense. What's going on with the balljoints?

 

It was post made in haste..it made sense to me...at the time .. the answer was/is Patience

jim