well hurry up and get them up...i would like to see that car again

i hope i can get more paint today...but i guess i will just have to wait and see..i just wanna drive it[:@]
though i cant wait to see it sitting on the engine stand fully assembled...
as long as nothing goes wrong with it i will be good to go....by the time the motor is done i will probally have more in it then i paid for the car[&:]

 

What size pistons are those? Did u have to bore anything out?

 

you were riped ofon it so it's not your fault i paid about 80$ for my boring on my v8 and i did the rest of the work so it was free labor

 

cost me $1052.28 to get the block bored .20 over, honed, hot tanked, deck the block, everything jet washed, preped the block, ground, polished, and baanced the crank, replaced freeze plugs and also included a head gasket set, bottom end gasket set, and clevite 77 rod and main bearings
it ended up being alot more then i thought, but so far its been worth it

 

got some more paint last nite and put the final coat on
im gonna try and find out how much its gonna cost to get the head done this afternoon or tomorrow...depends on how work in the garage goes since i have a full schedule[&:]