do you have the trim for all 4 wheel wells? id like it for the whole truck but im having trouble geting it.

 

Check with your local salvage yard before you haul anything in. They are paying $120-175 a ton here in Kansas right now. Some of the places calculate the weight off of the title which is pretty much a rip off. The places you want are the ones where they weigh the trailer/truck going in and the trailer coming out and pay you for actual weight. You can also throw scrap metal in with it. I'm going to be hauling in some stuff for my uncle soon and have collected washers, driers, water heaters, etc. to throw in the back of a van we are junking.

I just got a parts truck for the cost of gas to pick it up. A friend of mine's dad had it. Ran and drove fine except for a tranny leak when it was parked a couple of years ago.

Derek

 

nemesis ,yes i do have the trim for all four wheel wells i will take them off in the morning and post a picture of them for you to see whether or not you want them.i just looked at them with a flashlight and they are going to need some straightening out but they are intact.if you do want them ill take 20 dollars for the whole set with the screws plus what it cost to ship them to ya.


thanks for the info pushnfords,looks like you got a nice ram there. you should refurb it......our scrap yard pays by wieght here they weigh you goin in and coming out and yes i plan on putting as much as i can on it when i go....they are paying 100 dollars a ton as of monday when i talked to the crane operator there.

 

Yea, I hate to use that '85 as a parts truck. Rust free, highly optioned, one dent in the passenger rocker panel etc. But I need a 4wd. So the plan is to put the cab, engine, and front clip on my 4wd frame. I'd love to swap the bed too but when the PO put the flatbed on my truck they cut off the rear of the frame rail to make it fit!

Derek

 

ok i took off the wheel well trim this morning and washed them up they are not as pretty a set as i thought i tried to take some good photos for you too look at nemesis......




hey that should be a good flat bed truck when you get it swapped out Derekthough it is a job trying to rework and update these ole rams. i have thought several times i was wasting my time on mine but i have grown to like fixing the ole gal up.i hope to have her lookin good next year.good luck on your swap...if you have questions this is the place to get ansewers...

 

where are you? im in Whitby, Ontario. need to figure out ship;pign

 

i will be shipping out of Ecru,MS U.S.A. 38841-9723 5lb package.i dont know your shipping zone/zipcode they are like 3 different ones for Whitby, Ontario Canada. the postal service says they cant give me a price until i know the address and so did UPS...

 

sorry ive got trouble remembering all 50 state abbreviations. MS is MiSsouri or of MineSota? Ive got no idea how to do any of this. ill PM you specifics, you reply with how you want me to pay

 

hey nemesis i sent a pm dont know if you got it or not but shipping is 30 dollars from mississippi where i live and i dont think the trim is worth shipping plus cost of trim.....my professional opinion

 

it sure isnt