that roll bar looks pretty good. i want to make something like that for my truck. i would also want to have a piece of tubing going from the front pocket to the back pocket to use to tie things down.

 

i just need a push bar and i set

 

a push bar would be ok but i want to get an old tow truck bumper like my dad use to have on his crew cab. it was pretty much a piece of spring steel with some rubber mats bolted to it. the black drawing is the roll bar i would like to make for my truck. my truck has only 4 pockets in total so it is harder to secure a load.

 

those would be nice to have, but to top it all off i want
moose horns on my hood

 

looks good, i really like the roll bar. were are you located in Ontario? im just outside Niagara falls.

 

im kitchener

 

cool, if your looking to do a motor swap, the engine shop i work at has a 318 block, with crank in it. we gonna scrap it so you'll probably get it for dirt cheap

 

Does anyone have rotted floorboards like I do ....lol

 

pm when your getting ride of it, we will make arrangements

my drivers side is pretty bad

 

good work bud