DodgeForum.com

1st Gen Ram Tech '93 & older Rams: This section is for TECHNICAL discussions only, that involve 1993 Rams and older. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

wanting to swap out a dana 44 for a dana 60

Thread Tools
 
Search this Thread
 
Old Feb 13, 2010 | 02:07 PM
Share
  #1  
BIG BAD BENTON's Avatar
BIG BAD BENTON
Thread Starter
|
Registered User
Joined: Feb 2010
Posts: 11
Likes: 0
From: Bushkill Pa
Default wanting to swap out a dana 44 for a dana 60
i posted before about haveing problems with broken axles in a dana 44 and i was wondering how hard would it be to swap in a dana 60 can i just take out the 44 and have the 60 bolt right up and have the front drive shaft fit good or do i need differnt parts thanks for looking
 
Reply
0
Old Feb 16, 2010 | 10:39 AM
Share
  #2  
aaron7's Avatar
aaron7
Veteran
Joined: Oct 2005
Posts: 365
Likes: 1
From: MA
Default
Dunno but my D250 has a D60 factory so if you need pics or measurements let me know.
 
Reply
0
Old Feb 16, 2010 | 08:52 PM
Share
  #3  
BIG BAD BENTON's Avatar
BIG BAD BENTON
Thread Starter
|
Registered User
Joined: Feb 2010
Posts: 11
Likes: 0
From: Bushkill Pa
Default
that would be great thanks very much i would need the length of the front drive shaft also
 
Reply
0
Back to Subforum
1st Gen Ram Tech
View Next Unread
Engine dies at low rpm with headlights on




Advanced Search
Reply Closed Thread Share
Forum Jump

All times are GMT -4. The time now is 10:15 AM.