When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
1st Gen Ram Tech'93 & older Rams: This section is for TECHNICAL discussions only, that involve 1993 Rams and older. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
there is a plug on the driver side about half way down the transmission that has an orange/blue and blue wire connecting to it. I dont see anywhere for it to plug in, but can anyone tell me what it would go to?
as far as i can tell if you got a plug with a blue wire and a orange wire with a green stripe unplugged then i don't think your trans should even be going into overdrive.
if you turn the od off with the button, it runs and shifts 1-3 great, if you turn od on it shifts 1 to 2 fine, but when it trys the 2 to 3 shift its like it skips 3 and goes into od. during the 2 to 3 shift it acts like it kinda bogs down (very little) then goes into od. and i wondered what the plug was that wasnt hooked up may have something to do with it. what sensor does the orange with green stripe and blue wire go to?
Last edited by jester7225; 10-28-2012 at 07:26 PM.