When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
1st Gen Ram Tech'93 & older Rams: This section is for TECHNICAL discussions only, that involve 1993 Rams and older. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
yeah I would just do an axle flip on the rear and a 2 in drop spindle on the front that would make it sit relatively low and would still have that fairly smooth factory ride that these trucks have.
yeah I would just do an axle flip on the rear and a 2 in drop spindle on the front that would make it sit relatively low and would still have that fairly smooth factory ride that these trucks have.
I haven't looked at the drop spindles yet but thanks for the idea, might save some money!
how much lower will my truck set in the front when i replace the slant six with a 440? also wanting to find a good aftermarket lowering kit to purchase,that works. any ideals or websites
how much lower will my truck set in the front when i replace the slant six with a 440? also wanting to find a good aftermarket lowering kit to purchase,that works. any ideals or websites
slant 6 weights 475 lbs and the 440 weights 670lbs. From what I found on spring rates I think it will lower the front about 1/4". Others can chime in if they actually done the same swap and measured before and after.