1st Gen Ram Tech '93 & older Rams: This section is for TECHNICAL discussions only, that involve 1993 Rams and older. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

360 shuts off once warm

Thread Tools
 
Search this Thread
 
  #1  
Old 01-27-2013, 10:09 AM
bemisbunker's Avatar
bemisbunker
bemisbunker is offline
Registered User
Thread Starter
Join Date: Jan 2013
Location: Glady Wv
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
Default 360 shuts off once warm

please help 250 w/ 360 shuts off after it warms up a bit but fires right up when cold and after it does shut off it will not start back up for 15-20 min. This is my plow truck and we are getting hammered with snow any help would be great. Thanks
 
  #2  
Old 01-27-2013, 10:19 AM
junkman306's Avatar
junkman306
junkman306 is offline
Veteran
Join Date: Sep 2006
Location: Sparta
Posts: 297
Likes: 0
Received 0 Likes on 0 Posts
Default

Is it overheating or does it shut off once it reaches operating temperature?
 
  #3  
Old 01-29-2013, 05:41 PM
wicked872's Avatar
wicked872
wicked872 is offline
Registered User
Join Date: Apr 2011
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
Default truck dies

Originally Posted by bemisbunker
please help 250 w/ 360 shuts off after it warms up a bit but fires right up when cold and after it does shut off it will not start back up for 15-20 min. This is my plow truck and we are getting hammered with snow any help would be great. Thanks
I had a 93 Ramcharger that was my plow truck and did the same thing turned out after much swearing and hair pulling was the pickup coil in the distributor, good luck
 
  #4  
Old 01-31-2013, 11:20 PM
moe7404's Avatar
moe7404
moe7404 is offline
Record Breaker
Join Date: Jul 2007
Location:
Posts: 2,040
Likes: 0
Received 0 Likes on 0 Posts
Default

ballast resistor? dist cap? stuff inside the dist? coil wire?
 
  #5  
Old 02-16-2013, 12:02 PM
bemisbunker's Avatar
bemisbunker
bemisbunker is offline
Registered User
Thread Starter
Join Date: Jan 2013
Location: Glady Wv
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
Default

I have now replaced the fuel and air filters, fuel pump relay, dist. cap button ignition coil, pick up coil, plugs, wires and I am currently trying to locate the crank sensor but cannot find that thing for the life of me, does it even have one? and can anyone think of anything else for me to try. thanks
 
  #6  
Old 02-16-2013, 01:06 PM
crazzywolfie's Avatar
crazzywolfie
crazzywolfie is offline
Legend
Join Date: Jun 2009
Location: orangeville ontario
Posts: 8,024
Received 71 Likes on 67 Posts
Default

Your truck should not have a crank position sensor
 



Quick Reply: 360 shuts off once warm



All times are GMT -4. The time now is 05:57 PM.