Well hope this is the right place to post this...just recently purchased a Dakota 5.9 magnum R/T 1999 with only 12500 miles on it, was a one owner project that did not get done... I have finished it but would like to know where you can find what all the original options were on the truck, like I can with other's like my Trans Am and corvette.. so far have not found a place that lists them, and the codes in the glove box are not what I am use to seeing... so how would you find these?.. PS... not original at this time at all... a lot of goodies including the bored out 360 what was in it... know that it is one of 4110 1999 R/T club cabs made in 1999... that is it..flame red paint and black stripes...the "fanger"

 

take the vin number to the dealership. they should be able to get all the info for you.

 

Here: http://www.chrysler.com/webselfservi...sler/index.jsp

Send them an email and just put Vehicle Build Sheet in the reason box and they will email you your factory build according to the last 8 digits of your VIN.

 

Just wanted to say thanks for all your help..will do both just to see if there is any difference...

the "fanger"

 

Well I went to the site that you posted and guess what... they sent me everything about the truck including one recall that has never been done... I have to say I much appreciated your help...thanks a lot.... the "fanger"

 

I got my build sheet today too. Thanks for the link.

Jimmy

 

Anytime.

And good luck with the restoration Puppy.