Hi everyone, I'm a new dakota owner, I purchase a 99 dakota 3.9 2wd automatic with a blown engine. I purchased a new engine but when I went to pull the old one I managed to break two of the transmission connectors. My question is can anyone give me a picture of the 42RE (or tell me what order the wires go) into the output shaft sensor (should be a 2 wire) and the connectors on the left side of the transmission. My only alternative is purchase another harness but those are quite expensive. I would be eternally gratefull if somone could snap me a few picks of the transmission wiring under their truck. Thanks for the help in advance.