Cranshaft Position Sensor
12-13-2009, 12:45 AM
Registered User
Thread Starter
Join Date: Jan 2007
Location:
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Cranshaft Position Sensor
The rubber grommet for Crankshaft Position Sensor on 1997 Dodge Dakota 5.2L fell in. Do I have to get it out or can I just get another? If I have to take it out would I have to remove the transmission to do it. Thanks
12-13-2009, 01:13 AM
Join Date: May 2008
Location: Apex, NC
Posts: 4,842
Likes: 0
Have you tried taking off the dust cover and looking for it with a flash light? Thats where I'd start. I would definately go in after it though!! Don't leave it with all the spinning parts in the bellhousing!
12-18-2009, 12:39 AM
Registered User
Thread Starter
Join Date: Jan 2007
Location:
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
How would I remove the dust cover of the bell housing? Thanks
12-18-2009, 01:50 AM
Join Date: Feb 2008
Location: Chicago, IL
Posts: 1,058
Likes: 0
Just two screws. Only cover on there.
12-18-2009, 02:09 AM
Join Date: May 2008
Location: Apex, NC
Posts: 4,842
Likes: 0
Well its not exactly that simple. The starter goes over it as well as the engine to transmission brackets. There are about a dozen bolts that need to be taken out and/or loosened to get the dust cover off.