DodgeForum.com

DodgeForum.com (https://dodgeforum.com/forum/)
-   2nd Gen Dakota Tech (https://dodgeforum.com/forum/2nd-gen-dakota-tech-67/)
-   -   Mph's dropped 5mph, blue smoke out tailpipes, pulled over and now wont start (https://dodgeforum.com/forum/2nd-gen-dakota-tech/304011-mphs-dropped-5mph-blue-smoke-out-tailpipes-pulled-over-and-now-wont-start.html)

logicsound Sep 16, 2011 01:13 PM

Mph's dropped 5mph, blue smoke out tailpipes, pulled over and now wont start
 
So I am driving down the highway (1999 Dakota sport 4x4 5.2) and the mph's dropped about 5mph and then it became slugish and I pulled over and shut it off. Now it will not start.

Background: I have been burning oil and been putting in about a quart a month and it has been overheating but was only a little hot at the time the engine cut out.

The engine will turn over and is throwing no codes, Oil level is good, I tried pouring gas in the throttle body and it still wont crank. it has spark What are my next steps? Thanks for any help!

T

thunder98110 Sep 16, 2011 01:20 PM

your probably blew your headgasket. is there oil in the coolant?

logicsound Sep 16, 2011 01:44 PM

Thanks for the quick reply, I just pulled off the radiator cap and then a leak started, as far as I can tell its coming from the waterpump, its leaking down onto the damper. I didnt see any oil, just water and coolant. Where is the drain for the radiator so I can see if theres any oil in it? and what are you thoughts on the leak after I pulled the cap?

THANKS!

thunder98110 Sep 16, 2011 01:48 PM

since you said you over heated, and your adding oil and burning it, i still be its the headgasket. not sure about the coolant leak. i think there is a petcock on the bottom of the radaitor somewhere. not sure exactly on the magnums.

logicsound Sep 16, 2011 02:08 PM

ok, found the peacock but turning it did nothing, pulled the bottom hose and it drained out, not much in there at all! maybe a gallon (not sure how much is suppose to be in there) didnt see any oil in there but tons of dirt and grit. How can I tell for sure that the head gasket is blown? before I tear it all down?

thunder98110 Sep 16, 2011 02:14 PM

compression test

00daksport25 Sep 16, 2011 02:35 PM

For the petcock, you need to turn it and then pull it out slightly.

logicsound Sep 16, 2011 02:38 PM

oh, I guess that would help...Thanks! Working on checking the compression now.

98DAKAZ Sep 16, 2011 02:58 PM

I never use the little drain valve
 
I never use the little drain valve I did at one time till a few just snapped off on me or would never close all the way so now I just pull the lower rad hose faster and no worry of a snapped off valve or a leaky valve.

Sounds like it needed a system flush.

You may have a half plugged rad by the sounds of what you say when you talk about all the grit that came out a new rad may be in order.

logicsound Sep 16, 2011 03:07 PM

yea tried pulling petcock out wouldnt budge, just pulled hose.


All times are GMT -4. The time now is 06:36 PM.


© 2026 MH Sub I, LLC dba Internet Brands