Hi all. Im going to be replacing the crankshaft position sensor on my 98 Dodge Dakota V6 this weekend. Can anybody tell where this is located? I'd love to have some kind of diagram or picture, but if not I should be good if someone can just point me in the right direction.

 

In the back of the motor in between the transmission bell housing and engine block, passenger side. 2 bolts hold on the bracket.

I will move this to the 2nd Generation Dakota Sub-Forum.

 

Ok awesome. Just one more question. Would it be located inside the bell housing or on the outside? Also forgot to mention that its an automatic transmission. Just FYI.

 

Outside. Its a pain to get at, well might not be to bad on a v6 I did one on a v8 and it was terrible to get at.

 

Thanks bud. Yeah hopefully it wont be too bad