2 Attachment(s)
|
I think that will work. Thanks!
|
Originally Posted by 01dak3.9
(Post 3079264)
I think that will work. Thanks!
Those wheel studs are 7/8" for comparison. |
Is there any place I can get 5 lug axle shafts for the 9.25? Or will I have to re drill? Are there any hubs I can fit to the front end to make it 5x4.5?
|
no 5 lug shafts that I know of. You might be able to call Strange or one of the other axle makers, I'm sure they can make you one. Or try Baertrax in Dallas, Texas and tell him the orange car sent you. He does our rear-end work and he does alot of jeep axles. He may be able to cut a 5 lug set.
Like Tom said, if you can score a full width front end, you may be able to make it work with a deep offset wheel. You would need a wider rear axle, though. The best of both worlds, if you can make it happen, is to average the backspace required for a common centerline. IE if you do a 7 inch wide rim, you can run it as a 5 inch offset in front for the wide axle and a 2" offset in back for the narrow axle, and get a fairly close centerline. |
Hey, magnethead. Have you ever raced at Prescott Raceway? Your car looks familiar.
|
That would be a good project. I did a SAS too, you can find my build in my signature.
|
Originally Posted by 01dak3.9
(Post 3079394)
Hey, magnethead. Have you ever raced at Prescott Raceway? Your car looks familiar.
|
Ok. Just wondering.
|
All times are GMT -4. The time now is 10:05 PM. |
© 2024 MH Sub I, LLC dba Internet Brands