more proof that our trucks are Tonka Tuff
Thread Starter
|
Legend
Joined: Feb 2005
Posts: 8,058
Likes: 184
From: Fort Worth, TX
more proof that our trucks are Tonka Tuff
I had my truck at the local tech school to borrow their alignment machine (I helped them with some electronics stuff in trade), and happened to notice this. Proof again that our trucks are well built....and that loktite is worth it's weight in diamond.
If you don't get it, go look at yours and compare...
20131011_105104.jpg
If you don't get it, go look at yours and compare...
20131011_105104.jpg
Last edited by magnethead; Oct 11, 2013 at 02:58 PM.
Amateur
Joined: Nov 2008
Posts: 29
Likes: 0
From: Canada
I don't quite get it. Looks like a rubber core plug replacement has been installed in the block, and maybe doing that required getting the mount out of the way, and maybe that's why the mount came off if it wasn't properly tightened.
Just because the engine is resting on the crossmember doesn't make it a tough truck.
I've busted all three mounts on a car - two engine and the trans - and drove it for a bit.....not long....but it drove.
Just because the engine is resting on the crossmember doesn't make it a tough truck.
I've busted all three mounts on a car - two engine and the trans - and drove it for a bit.....not long....but it drove.
Site Moderator-Dodge Tech
Joined: Sep 2010
Posts: 3,724
Likes: 22
From: Nashville, Tennessee
WUT ? Zoom out ...I can't seeeeee!! 
I gotta put ball joints and upper control arm bushings on mine tommorow......sonofa
I gotta put ball joints and upper control arm bushings on mine tommorow......sonofa
Last edited by TNtech; Oct 12, 2013 at 12:13 AM.