Check out the new AEM Brute Force intakewith Dryflow filteron Chrysler Aspen with 5.7 Hemi also fits durango with Hemi. This kit was installed in less than 30 minutes and was a perfect fit. The heat shieldhas three attachment points 1) under swaybar mount 2) upper radiator support 3) in factory air box location. The tubing is mandrel bent polished aluminum with a tig welded bracket that goes to a soft mount located in location on top of intake. The air intake temp. sensor went back in tube near factory location.The kit went in like a factory part one of the easiest kits I have ever installed and I have done quite a few.During the test drive we found quicker throttle response, butt dyno says a gain in power, not to mention it sounds like there is an aftermarket exhaust system. This is the only performance upgrade on the vehicle. The ownersaid she didn't wantanything done to her new suv and her husband said change the oil put on the intake. When I returned the Aspena few hours past I recieved a phone call. when she went to get the kids at school something was different and she loved it could I get one for the 300c.I didn't have the heart to tell herI had putaBrute Force intakeonbefore her husband left for spring training. She just hadn't been in the car yet.If anyone wants to see pics of 300c also fits chargerI can post them also.

[sm=gears.gif]

[IMG]local://upfiles/61978/4A30F8EC662A4B96B20FF1C537FFF111.jpg[/IMG]

[IMG]local://upfiles/61978/9AA99F5624F24550B7C39D9D2BC479F1.jpg[/IMG]

[IMG]local://upfiles/61978/6DA0BABF7AEC462BADD2358C9C975E37.jpg[/IMG]

[IMG]local://upfiles/61978/54A199029480424B8D8EEE306F19E7F4.jpg[/IMG]

 

Nice set-up!