I just had the shop change the door lock actuator and the dumbys mess up my power window adjusting switches. They provide no resistance so I am guessing they forgot to plug something in. How do I take the driver's side door panel off to fix this? Thanks.

 

what year car ?

 

Sorry its a 2000

 

sorry then i can't really help ya. i got a 1998 and mines easy. just a torx bolt behind door handle and a little srew where u pull the door shut. and then it pops off (only clips hold it on behind that) check to see if urs is the same built i doubt it. also u can try the autozone site they hve a help section that might show u how to do it. or wait for some one else to notice this topic and help out lol

 

I would bring it back to the place that did the door locks.

 

I tried too but i work all week and they are closed on Sat/Sun. I was gonna just do it myself and save some headache if at all possible. Can anyone help me out?

 

hell, just look around for any screws or tabs. experiment a little, just don't force it too much.

 

All you do is take the two screws out , one in the arm rest and the other behind the door handle then pop the clip on the window crank then use a panel popper to pop the panel off ~ good luck

 

kool thanks

 

watch there are 3 screws then click if off