Side Marker Lights
never done mine before but there should be a couple of screws holding your amber ones to the bumper. if you stick your hand up there, see if you can get a screwdriver in there. you might need to remove the air intake baffle box thing that attatches there. then its just a simple swap. remove wire harness and bulb from amber side marker, install clear side marker, install harness and bulb to new side marker. and your done. real simple.
ORIGINAL: amacgenius

That's the part I want to replace, I've got a set of clear ones that I've been itching to put on my Neon, any help anybody?

That's the part I want to replace, I've got a set of clear ones that I've been itching to put on my Neon, any help anybody?
removing those is simple. Just go underneath the bumper and see where the maker is at. You will then see a pin holding the marker in place (you may need a flashlight to see it) pull that pin out then you can remove the marker. Disconnect the connector (which has the bulb) from the marker and put in the new one. Then do it the same way for the other side.
ORIGINAL: Adionik
If you can't change your sidemarkers blind folded then you seriously shouldn't be allowed near a Neon. It's the easiest thing to swap out next to the spoiler
If you can't change your sidemarkers blind folded then you seriously shouldn't be allowed near a Neon. It's the easiest thing to swap out next to the spoiler
It is only held on by a metal clip. Granted one of them was a bit of a pain to remove, but still not that hard.


