2nd Gen Neon 2000 - 2005 2nd Gen Neon

Manual transmission swap

Thread Tools
 
Search this Thread
 
Old Sep 23, 2009 | 03:30 PM
  #1  
2004SE's Avatar
2004SE
Thread Starter
|
Registered User
Joined: Aug 2009
Posts: 19
Likes: 0
From: Sumter, SC
Default Manual transmission swap

Alright, I have a 2004 Neon SE model with an automatic transmission. I want to swap it out for a manual transmission, but I cannot find any locally, or in any nearby neighboring cities. I know I can find them on other sites, but I'd prefer to be able to go look at the transmission myself on a weekend or something, so I'm wondering what other transmissions will fit the Neon easily enough, and what I'd need for the swap, itself.
 
Reply
Old Sep 23, 2009 | 08:56 PM
  #2  
darthroush's Avatar
darthroush
Section Moderator
Joined: Sep 2008
Posts: 5,584
Likes: 7
From: Northern California
Default

There were probably other vehicles that used the same transmission. I'd look for those too, if you haven't. I wouldn't think any others would work without major modification to something.
 
Reply
Old Sep 24, 2009 | 10:39 AM
  #3  
Ghost Neon 2's Avatar
Ghost Neon 2
Record Breaker
Joined: Dec 2006
Posts: 1,216
Likes: 0
From: Baltimore, Maryland
Default

Here is a list of cars that have a 5 speed transmission that will bolt up to your neon:

94-99 neon manual transmission: swap the bell housing from the cable to the hydraulic

96-99 chrysler sebring, dodge avenger, non turbo dodge talon, non turbo mitsubishi eclipse
(NOTE: these vehicle have the same gear set used in the 1G neon r/t, which is geared for racing and not highway driving)
No bell housing swap needed for these cars

All PT cruiser 5speed transmissions will swap directly into a 2G neon
 
Reply
Old Sep 25, 2009 | 03:12 AM
  #4  
2004SE's Avatar
2004SE
Thread Starter
|
Registered User
Joined: Aug 2009
Posts: 19
Likes: 0
From: Sumter, SC
Default

Thanks. That'll make the swap a whole lot easier. There are Eclipses and PT Cruisers galore around here. Also, aside from the clutch assembly, master/slave cylinders, and flywheel, what else will I need?
 
Reply
Old Sep 25, 2009 | 11:22 AM
  #5  
Ghost Neon 2's Avatar
Ghost Neon 2
Record Breaker
Joined: Dec 2006
Posts: 1,216
Likes: 0
From: Baltimore, Maryland
Default

mtx Passenger side axle

2G shifter cables ONLY - 1G shifter cables are too short

5sp shifter and 2G boot

MTX pcm if you want wider range of engine control

Throw out bearing

You will have to wire in the reverse plug sensor. Pig tail required.

All I can think of right now.
 
Reply




All times are GMT -4. The time now is 11:12 PM.