ECU pinout
Thread Starter
|
Registered User
Joined: Sep 2017
Posts: 1
Likes: 0
From: South Dakita
ECU pinout
Ive recently installed an aftermarket tachometer in my 2000 Dodge neon 5-speed (didnt have a factory tachometer) i currently have the pulse signal wire for the tach wired into the signal wire in the ignition coil harness... i was told to wire as close to the ECU as possible but i cant seem to find a proper diagram for my make and model any suggestions ???
Captain
Joined: Jul 2016
Posts: 529
Likes: 18
From: SW Va
Welcome to the 2nd Gen Neon forum.
Look in the FSM pages 8W-80-37 & 38 in the Connector Pin Outs, for the ECM pin outs.
We can access the FSM by looking in the stickys section atop the forum index page & clicking on the Part#/Maintenance Interval/Fluid capacity link & when it opens, scroll down to the bottom center of the 1st post, under 2nd Gen Neon click on your year range to open a Google file. You'll need to be logged in to your Google account for it to open, then look at, or down load the file for future reference.
Look in the FSM pages 8W-80-37 & 38 in the Connector Pin Outs, for the ECM pin outs.
We can access the FSM by looking in the stickys section atop the forum index page & clicking on the Part#/Maintenance Interval/Fluid capacity link & when it opens, scroll down to the bottom center of the 1st post, under 2nd Gen Neon click on your year range to open a Google file. You'll need to be logged in to your Google account for it to open, then look at, or down load the file for future reference.