Not sure really. The audio place had it on the shelf. I'm sure they could hook you up. It's a very nice piece thaat blends in to the stock interior very well.

 

This is what I used;
Metra 99-6000 Single DIN Installation Kit for 1974-2004 Chrysler/Dodge/Jeep/Plymouth Vehicles -Black

The slot is perfect to wedge in an iPhone... I have a short cable to loop up to the Aux-In on the stereo.

 

Thanks for that. It's exactly why I asked.

 

Finally got my suspension redone. new 5.5 inch lift, ball joints, u joints, drive line, dual steering stabilizer, track bar, and wheel spacers. NEXT UP: new 17 inch rims on 35's

before and after lift

 

I didn't get any "before" pics because this was a spur of the moment project. I took my Ram 1500 that I bought last year for $800 and put it onto a Ram 2500 chassis that had been rolled.



The paint was trashed and I spread a little bondo here and there, so I decided to go cheap and cover it in bed liner.





The 2500 came with a 12" lift kit.





First trail test. Did pretty good. Still need to get the fenders lined up and a few small adjustments here and there.




I used the 5.9 and the 5 Speed manual out of the 2500 as they were not damaged and it was easier to just cut a hole in my floor and hang the pedals than to do an engine/trans swap.

 

^Nice work Dacamo. Any more plans? You are money ahead.

 

I have a few things I'd like to do. A winch is in the works. I already have a light bar for the front. I just have to cut/adjust/re-weld the mounts (It came off of a Chevy). I'd like to get a roll bar/light bar in the bed or if I start feeling unusually confident I may attempt to fabricate an exoskeleton.

Since I have 2 of everything in the cab, I'm thinking about doing a custom interior project. Not sure exactly how that'll go.

This is all assuming I get the time to tinker with it.

 

Snagged a pic after rinsing it off today. Got to like 80 degrees!

 

Dang Nab 80* in ND!!!!! It was like 50* for a high here in WA. I'd like to see 60+ for a week right now.

 

Got the Cummins motor bored out finally! Here's a pic of the block!