The Camo Beast as it Evolves.
#23
#24
Thanks 44 Dakota. I was looking into the hobarts and was unsure of which way to go and then said what the f#@& and went for the millers. It was the 200 hrs of overtime in January and February that enabled this venture. Keep at it and it will happen for you
Last edited by corbo1962; 03-29-2014 at 10:08 PM.
#30
Ham, I've been collecting them for allot of years and stepped it up some in the last couple.
Johnny, thanks! I got the 220 v power in today for the welder. Also got three 20 a 110 v outlets in. One is a circuit that is dedicated to the air compressor and the other circuit has two outlet for the drill press belt sander and reloading bench.
Tomorrow I'm going to get the staun bead locks installed. It's the last day of this vacation. Back to work on Wednesday nights for the grave yard shift
Johnny, thanks! I got the 220 v power in today for the welder. Also got three 20 a 110 v outlets in. One is a circuit that is dedicated to the air compressor and the other circuit has two outlet for the drill press belt sander and reloading bench.
Tomorrow I'm going to get the staun bead locks installed. It's the last day of this vacation. Back to work on Wednesday nights for the grave yard shift