2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Need some enigne help

Thread Tools
 
Search this Thread
 
Old Apr 12, 2007 | 12:39 PM
  #1  
sephirothq's Avatar
sephirothq
Thread Starter
|
Professional
Joined: Mar 2006
Posts: 120
Likes: 0
Default Need some enigne help

I have a 95 1500 4x4 with a 5.2. lately when i am driving the truck with start bucking. if i let it idle the rpm are surging up and down, i noticed that my cruise control has stopped working and it always worked beofre. and my fuel mileage has dropped. but it is not a constant problem it doesn't act this way right away, but once it starts it won't stop until you shut off the truck.
I am thinking it could be the fuel pump, computer or the intake.
any ideas? any help?
 
Reply
Old Apr 12, 2007 | 03:47 PM
  #2  
tdmopar59's Avatar
tdmopar59
Grand Champion
Joined: Feb 2007
Posts: 5,704
Likes: 0
From: Warminster, PA
Default RE: Need some enigne help

Well you might want to give the truck a full tune up air cleaner, plugs, wires, cap, rotor, and pcv valve and i believe that you can reset your pcm extremely easy by disconnecting the battery for 15 minutes then reconnect it.... it might run wierd right away but let it idle for a little bit but then it should be all rite.... give it a try
 
Reply
Old Apr 12, 2007 | 09:32 PM
  #3  
sephirothq's Avatar
sephirothq
Thread Starter
|
Professional
Joined: Mar 2006
Posts: 120
Likes: 0
Default RE: Need some enigne help code 51

Today i finally got a code
code 51
it says that it is running too lean.
i guess next is to check the fuel pressure and check for vaccuum leaks.

Any ideas to what could cause this?
What should the fuel presure be?
What should the vaccuum read?

 
Reply
Old Apr 13, 2007 | 03:00 PM
  #4  
Jonah Hex's Avatar
Jonah Hex
Registered User
Joined: Apr 2007
Posts: 11
Likes: 0
From: Hillsboro, Illinois
Default RE: Need some enigne help code 51

Fuel pressure should be 50 psi according to my Haynes manual and I pull about 20" of vacuum at idle.


Jonah
 
Reply




All times are GMT -4. The time now is 10:43 PM.