When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
from what i know, you'd have to have the dealer program in the VIN, the basic swap is pretty simple, it's mounted on the firewall, passenger side with 3 big wiring harnesses on it.
For about the same thing the dealer will charge you, you could buy a used one and send it to B&G. They will flash your vin in along with some 'changes' that will make you think you are driving someone elses truck.
Easy. One 60 pin connector (5/16" bolt holding it in) three bolts holding it to the firewall (I think they are 5/16 or 3/8", can't remember). Takes 10-15 minutes. Make sure neg batt cable is disconnected!
RE: PCM replacement
