wise? torch and ujoints
#12
RE: wise? torch and ujoints
i used a big table vice, a socket that is the same size as the u-joint cap that holds the needle bearings in and a, hammer a BFH (3 pound sledge.)
good luck
and how did we end up going from U-JOINTS to BALL JOINTS
they dont even come close to being the same unless you have a magic BALL JOINT the make the driveshafts turn.
good luck
and how did we end up going from U-JOINTS to BALL JOINTS
they dont even come close to being the same unless you have a magic BALL JOINT the make the driveshafts turn.