2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Installed my Panasonic Deck and

Thread Tools
 
Search this Thread
 
Old Mar 3, 2008 | 10:36 PM
  #1  
kowboydmac's Avatar
kowboydmac
Thread Starter
|
All Star
Joined: Oct 2007
Posts: 948
Likes: 0
From:
Default Installed my Panasonic Deck and

found out that the previous owner had NO PATIENCE and nearly every piece of the inside dash console was broken. I can't even screw in my ashtray or cup holder because everything is broken in there. Luckily my Radio unit holds in by two screws that maintain it's position.

Man, kinda frustrated. Anyway, when I go about replacing the heater core, I want to replace these dash errors. Would have taken a pic but got caught up trying to figure out where to put everything, once it was in there, didn't want to take it back out, lol.

So my question for you is, is it possible to buy these piece? I know I could pull it off a junk 1500 but that's no guarantee it will be in any better condition. If worse comes to worse, I'll fab up some fiber glass and use some of those white screw holders used in home building.

Alright, I'm off to the wanted classifieds to post there.
 
Reply
Old Mar 17, 2008 | 10:15 AM
  #2  
engineblock's Avatar
engineblock
Veteran
Joined: Oct 2007
Posts: 381
Likes: 0
From: Laredo Texas
Default RE: Installed my Panasonic Deck and

no u have to replace the entire bottom piece
i had the same problem but while i was looking on ebay around Sep last year, i stumbled into a seller that was seleing it, i was the only bidder and i won it for 1dollar. but with ur question u have to replace the entire bottom console, you can also glue them but they will only come off in a while.
 
Reply




All times are GMT -4. The time now is 07:44 PM.