So about a week ago I installed the Autometer Dual A pillar pod that I picked up from Geno's Garage. I wired in an Autometer Cobalt Digital Trans Temp Gauge and an Innovate DB-Blue Digital A/F meter with an LC-1 wideband O2 monitor.

The install was pretty easy and straight forward thanks to Mayfair's guide. Luckily, I didnt have broken clips like Mayfair did. I just drilled holes in the original A pillar with a 1/2" tile drill bit and glued the new pod mount to the old A pillar with some 3M emblem glue. The fumes off the glue werfe a little strong, but the truck was a little more fun to drive for about 2 days after the install.

Anyway here's the installed pics, the trans temp gauge hasn't been plugged in yet as I don't have my new pan yet, but the pics are of the pod with a flash, the pods unlit and then working.

 

Lets see them on.

 

WTF is with the huge pics? Those fumes from the glue must still be affecting ya. Check the date, love your state.

Front servo port?

 

Photobucket is folding big time I can't get the pics resized....

 

Can you show me Mayfair's guide?

 

damn i could almost see the engine through the vent! LOL

 

LOL! I centered my hands up on the "wheel" just for fun and I think it even bigger than life sized.

 

fixed! whew

 

Yep, thats Mist Grey.

 

I know that's mist gray you crazy boob! My A pillars and Door panels are a lighter shade of Gray than the dash was. believe me I know. I painted he whole damn replacement dash mist gray and when I slid it in the truck, it didn't match the lower or upper dash, but matched the A pillar and doors great. I think they put my truck together with some off parts.