2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Quick help after heatercore swap

Thread Tools
 
Search this Thread
 
Old Jun 4, 2009 | 11:28 AM
  #1  
wokaman's Avatar
wokaman
Thread Starter
|
Registered User
Joined: Jun 2009
Posts: 11
Likes: 0
Default Quick help after heatercore swap

Hi, I just finished replacing my heatercore on my 99 ram (with the awesome help from u guys) and cant remember which color vaccuum hose goes to which cannister under the dash...red,yellow, brown... also i noticed the vaccuum line that come out of the dash with the ac line...where it T's off ... came loose..it looks like it goes to the backside of the motor..maybe distributor? Any help would be great..
 
Reply
Old Jun 4, 2009 | 01:25 PM
  #2  
Sheriff420's Avatar
Sheriff420
Grand Champion
Joined: Apr 2008
Posts: 7,055
Likes: 7
From: Lee County, North Carolina
Default

http://www.flickr.com/photos/2965453...63143/sizes/l/

i just put this on your other thread.

http://i412.photobucket.com/albums/p...0081558-00.jpg

this is a picture of where that vac line goes. it hits that t then goes to the intake manifold and over to the cruise control servo. make sure you have that check valve in the t or you will have the wild vent issue, what happens when you have that is under acceleration with the air on it'll switch the air from the vents to the defrost. if you get that issue and the check valve doesn't fix it, then there is another one on the side of the manifold and changing it should fix it.
 

Last edited by Sheriff420; Jun 4, 2009 at 01:28 PM.
Reply
Old Jun 4, 2009 | 01:44 PM
  #3  
wokaman's Avatar
wokaman
Thread Starter
|
Registered User
Joined: Jun 2009
Posts: 11
Likes: 0
Default

Awesome help sheriff!!! however i was mistaken on the line from the T... the one that came off is actually a green vac line with an elbow that is sitting on top of the t-case right now..coming out of a harness with another vac line...behind the dist....there isnt much slack in it so it must be somewhere close..any ideas??? Thanks again for your help
 
Reply




All times are GMT -4. The time now is 12:21 AM.